In this article we will study all about MSRM US302 Wi-Fi 300Mbps dual range extender. Here we go, in case you’re looking ahead to decreasing the dead zones in your home or office. Then MSRM US302 repeater is often good selection for you, with its newest features like universal compatibility. Moreover, for this installation, you do not require any CD you’ll effortlessly access its setup via phone or laptop. For good performance, you’ll even setup MSRM US302 extender as an Access Point also, which can offer you way faster speed a bit like your router. Its three LED lights located on the front are for power, client’s status and Wi-Fi status. So, let’s begin the configuration process.
US302 Range Extender Setup via Browser
Follow these MSRM Wi-Fi extender setup instructions:
- First locate your MSRM Wi-Fi extender mid-way between your router and where you want to boost your Wi-Fi.
- Then hold on for moments until power LED turns stable on the MSRM repeater and connect it with your device like laptop/computer/phones, etc.
- Now check out the Wi-Fi list and find MSRM default network name there. You might see “Wireless-N” or “Wireless_AC“.
- Once you find it then connect with that network name, for very first time it will not ask for any password to connect. Moreover, you will see “No internet” when you are connected to it.
- Now launch browser on your device and in the address bar type http://ap.setup or http://192.168.10.1 , wizard automatically pop up.
- Now you need to select the mode as repeater/extender and click Next. It will take you to login page fill credentials as “admin” in both username and password.
- Then, select the network you want to extend and type its password.
- Make sure to complete the setup and after that, the MSRM US302 repeater will reboot which hardly takes 60 seconds.
- Final step is to connect your devices to the new Wi-Fi network that you created (SSID_EXT).
US302 MSRM repeater setup via WPS
US302 MSRM repeater setup via WPS is very easy to setup it will hardly take 10 minutes. So, let’s begin with the steps:
- Firstly you need to do is plug the extender in the same room where your router is placed.
- Now you will see the power LED gets stable then press the WPS button on US302 repeater.
- Once you done the process, you will see with 2 minutes lights starts linking on both the devices.
- Now configuration is successfully done, you will see WPS on the router will stop blinking and on the extender it will turn solid.
- Final step, see in your Wi-Fi list and connect your devices to the newly created extender network that’s SSID_EXT with an equivalent password as your router.
Configure US302 repeater as an Access point
In case you’re trying to find good speed transmission from this device then setting it up as an Access point will the simplest option for you. For this need Ethernet cable as per requirements. Just in case you would like to the present extender 20 feet far from the router then use 20 feet long cable. Plug one end of the Ethernet into the extender and therefore the other within the LAN port on the router.
- Firstly you need to connect your devices like laptop/phones with the repeater’s Wi-Fi network i.e. MSRM network name is in your Wi-Fi list.
- Now launch browser (chrome, Firefox, etc.) and in the address bar enter the IP address “192.168.10.1”.
- Once you done then you will see the login page. In the credentials enter “admin” as username and password.
- Now you need to select the mode as “Access point” once and continue the setup.
- Then enter the name you wish for your access point, its password and its security type and click Next.
- Once you done with the entire procedure apply the settings and will reboot for 60 seconds.
- Final step is to connect your devices with the new access point that created by you.
Your configuration of US302 repeater as an Access Point is successfully done.