⚡ Quick Answer: Victure Wi-Fi Extender Login Quick Steps
Follow these quick steps to access your Victure range extender setup page:
- Plug in device: Plug the Victure extender near your router and wait for the power light to turn solid.
- Connect to Wi-Fi: Join the default wireless network named
Victure_xxxx_2.4Gfrom your phone or PC. - Open setup portal: Navigate to http://192.168.10.1 or
http://myrepeater.netin any browser. - Enter default credentials: Username:
admin| Password:admin. - Pair with router: Select your home Wi-Fi SSID, enter the network password, and save.
Setup for Victure Wi-Fi Extender login via web domain
Follow the below steps to setup of Victure Wi-Fi extender via web domain:- In the initial step, you need to plug in your Victure Wi-Fi extender into a wall socket.
- Now, hold on for 40 seconds till LED lit up.
- Once you see then connect your device with your Wireless network.
- The SSID named WIRELESS-XXXX by mobile and password will be null.
- When your device gets connected then open any web browser on your device.
- And, enter in the address bar http://wireless.repeater or 192.168.10.1 and click enter.
- Then, you will see the login page.
- After that, enter the username and password as admin and click enter.
- Here setup page will appear.
- You have to select the language and clicks enter.
- Go to the setting page and select your home Wi-Fi router and enter the password and click NEXT.
- In the end, click on the button on the bottom to finish the setup.
- When it is done then the Victure repeater will restart.
- Victure extender setup is successfully done.

The Difference of Extender Mode and AP Mode
Extender Mode (Wireless Connection)
You can choose use Mobile phone or PC to set up via the set up page.AP Mode (Wired Connection)
You have to use mobile phone or PC to set up via the set up page. (Ethernet cable is required)- Extender Mode-
- Firstly, click the “Wireless Scanners” at the upper right corner.
- After that, choose a primary network and then enter the password of your primary network password.
- Then, Set the SSID and Password for the extended wireless network.
- (SSID is the name of Wi-Fi. It must within 23 words.)
- You could select “The extended wireless network name and password are consistent with the primary network”
- If you select this, then the extended wireless network SSID is XXXX-2.4G-EXT or XXXX-5G-EXT and the password is the password of primary router one. (XXX is the name of primary router)
- And you have to choose “Modify wireless network extension and password.”, and then set the new the extended wireless network SSID and password below in this set up page. Next, click ”Save’
- You have to wait for some time, until the indicator light turns green orange.
- If green is great. If orange, please place the Wi-Fi extender and router closer.
- Firstly, Click the ”AP mode switch” and then click “Next”
- After that, Set the extended wireless network name and password
- Now, Use an Ethernet cable to connect the Wi-Fi extender
- Then, you have wait for few minutes until the indicator light turns green or orange.
